AVAILABLE AT:
DIRECTIONS:
1. PROTECT: Work area must be protected from accidental spills.
2. CLEAN: Surfaces must be clean, dry and free of grease and oil.
3. PREPARE: Roughen smooth surfaces (using abrasives or sandpaper).
4. OPEN PACKAGE: Remove Syringe. Turn syringe nozzle end up and pull plunger back slightly (1/8″). Allow air bubbles to rise to top. Snap off and save storage cap. Push plunger to dispense equal amounts of hardener and resin onto discard-able surface such as a piece of cardboard. Mixing paddle will pop out from plunger. Pull back plunger tostop flow. Snap cap back on.
5. MIX QUICKLY: Quickly and thoroughly mix until blue color turns clear (about 15 sec).
6. APPLICATION: Apply small amount of mixture to both surfaces
and assemble parts immediately (product sets in approximately 60 seconds). Remove any excess epoxy immediately.
7. CURE TIME: Usable strength is reached in 1 hour at 72°F (22°C). Cooler temperatures may require longer set time. 8. CLEAN-UP: Attach nozzle cap and store in molded tray. NOTE: Adhesive will not bond most polyethylene or polypropylene plastics.
Substituted with PX84101
The Permatex® General Purpose 1 Minute Gel Epoxy provides the flexibility to reposition before the setting time. The fast setting, two-part adhesive and filler system is specially formulated with a Blue Dye Indicator that disappears when it’s fully mixed and ready to use. The advanced gel formulation reduces mess and waste compared to traditional epoxies; unique indicator system takes the guesswork out of “ready to use”.
