DIRECTIONS:
- PROTECT: Work area must be protected from accidental spills.
- CLEAN: Surfaces must be clean, dry and free of grease and oil.
- PREPARE: Roughen smooth surfaces (using abrasives or sandpaper).
- OPEN PACKAGE: Remove tubes and use a sharp point to puncture seals.
- DISPENSE: Squeeze tubes to dispense resin and hardener. Thoroughly mix resin & hardener on a clean, discardable surface for 2 to 3 minutes until evenly colored.
- APPLICATION: Apply a small amount of mixture to both surfaces and assemble parts immediately (working time is
approximately 4-6 min.). Remove any excess epoxy immediately.
- CURE TIME: Usable strength is reached in four hours at 22°C (72°F). Cooler temperatures may require longer set time.
- CLEAN-UP: Attach nozzle caps and store in molded tray.
NOTE: Adhesive will not bond most polyethylene or polypropylene plastics.
